![]() Click Save button and Yes when it asks whether you want to generate code. In the Pinout window, you can see that pins PB10 and PB11 are highlighted in green as USART3_TX and USART3_RX. We are going to use the same parameters on the host’s UART terminal, so that two devices can communicate with each other. In the Parameter Settings section, choose the following parameters: In Pinout and Configuration tab, select USART3 peripheral, select Asynchronous as the Mode of communication, and disable hardware flow control. You will see the Device Configuration Tool window. Enter a name and select location for your project and hit Finish. Then choose STM32F103VBTx variant and click Next button. Enter STM32F103VB in the Part Number filter (or choose your target STM32 chip). The STM32 Target Selection dialog will open which you can choose your target STM32 chip. Now open STM32CubeIDE and select File > New > STM32 Project. Building STM32 UART project Create a new project in STM32CubeIDE If you are new to STM32 development, check out our previous article to get started with STM32CubeIDE. We will be using STM32CubeIDE as the development environment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |